Toro 500 EFI Service Manual page 70

1. Remove the secondary driven shaft assembly (A)
noting the location of the front and rear bearing
locating pins and the center bearing locating ring.
2. Remove the reverse idler assembly (B). Account for and
note the location of the inner bushing (1), idler shaft (2),
and outer washer (3).
68
FI639A
3. Remove the driveshaft (C); then pull the shift fork locat-
ing shaft (D) out of the crankcase locating boss and
allow the shift forks to disengage from the gear shift
shaft (F).
FI660A
FI659A
4. Remove the gear shift shaft (F) noting the inner and
outer washers.
FI661A
FI641A
FI646
FI653A
FI650A