6. Install the shift fork shaft w/spring into the housing
making sure the shaft O-ring is positioned to the
inside.
7. Install the shift fork assembly making sure the fork
leg is facing upward. Apply a small amount of oil to
the gasket; then install the gasket.
8. Place the input shaft assembly onto the gear case
housing; then secure with the existing cap screws.
Tighten to 23 ft-lb.
NOTE: If a new housing is being installed, tighten
the cap screws to 28 ft-lb.
Removing/Installing Axle Seal
NOTE: This procedure can be performed on a rear
CC892
gear case.
1. Remove the seal using a seal removal tool.
CC893
NOTE: Prior to installing the seal, apply High-Per-
formance #2 Molybdenum Disulphide grease to the
seal outside diameter.
2. Using Gear Case Seal Installer Tool, evenly press the
seal into the cover bore until properly seated.
CD103
Make sure the tool is free of nicks or sharp edges or
damage to the seal may occur.
3. Repeat steps 1-2 for the opposite side.
CAUTION
CD110
CC899
CF278
155