Memory Channel Lockout; Quick Memory Scan; Configuring The Conditions For Resuming Scan - Kenwood TS-890S Instruction Manual

10 SCAN
Pressing F5 [SCAN] does not start the scan operation
●
when the memory groups to be scanned are configured
as follows.
• When the checkboxes for all the memory groups are
deselected.
• When operating data is not stored in the memory
channels of a memory group, even if the checkboxes
of the memory group are selected.
• When all the memory channels belonging to a
memory group are locked out, even if the checkboxes
of the memory group are selected.
Examples on the configuration of All-channel Scan and
●
Group Scan:
• When the checkboxes for Memory Groups 1 and 5 are
selected, pressing F5 [SCAN] activates Group Scan.
In this case, scan is performed on the memory
channels included in Memory Groups 1 and 5.
• When the checkboxes for all memory groups are
selected, pressing F5 [SCAN] activates All-channel
Scan.

Memory Channel Lockout

Selected memory channels can be omitted (locked out) in advance
before performing Memory Scan.
1 Press F7 [M.LIST] to display the Memory Channel
List.
2 Press F2 [ ] or F3 [
control to select a memory channel.
3 Press F6 [L.OUT] to lock out the memory channel.
• Lockout is applied to memory channels for which the
"Lockout" checkbox is selected.
• Pressing F6 [L.OUT] again cancels the lockout mode.
• "L.OUT" lights up in the standard mode screen and
compression mode screen.
.
4 Press [ESC] to end the process.
10-4
], or turn the [MULTI/CH]

Quick Memory Scan

Quick Memory Scan allows the registered quick memory channel
to be automatically switched at a specific time interval for
scanning.
1 Press [Q-MR>] to call up a quick memory channel.
.
2 Press F5 [SCAN] to start quick memory scan.
• Turning the [MULTI/CH] control allows the scan channel to
jump rapidly to the next or previous channels.
• Pressing F5 [SCAN] again or pressing [ESC] ends Quick
Memory Scan.
• The scan direction is fixed at the ascending order.

Configuring the Conditions for Resuming Scan

Scanning stops when signals are received while performing
Program Scan (VFO Scan) in the FM mode or during Memory Scan
or Quick Memory Scan regardless of the operating mode.
• The conditions for resuming the scan operation after it has
stopped can be configured.
Time-operated (Time-operated mode):
Pauses scan for 3 seconds after signals are received. Continues
to pause scan for another 3 seconds if signal reception is still in
progress after 3 seconds.
Scan operation resumes after this interval even if reception is still
ongoing. (The maximum duration for pausing scan using the time-
operated mode is 6 seconds.)
Carrier-operated (Carrier-operated mode):
Pauses scan while signals are received. Scan operation resumes
when signals are not received for a duration of 2 seconds.
Configure in Menu [4-05] "Scan Resume"
Setting Value Time-operated (default)/ Carrier-operated