3.
Insert a new battery as shown in the figure.
4.
Replace the cover of the battery compartment.
Connecting the ACDC Power Adapter
The system can run using AC or battery power. When the unit is plugged into an AC outlet, it uses
AC power and charges the installed battery.
To connect the system to an AC power outlet:
1.
Connect the female end of the ACDC power adapter to the power connector on the back
of the unit (A).
2.
Plug the male end of the power cord in the ACDC power adapter to the AC outlet.
3.
Check the power LED to make sure the unit is receiving power from the AC outlet.
NOTE:
2047426-001K
Use only the GE Healthcare recommended ACDC power adapters. The system requires a
working battery for printing ECG reports.
MAC™ 600
Maintenance
133