Turning On The System - GE MAC 600 Operator's Manual

To load the roll paper into the device, do the following:
1.
Open the Writer door.
2.
Remove the leftover paper from the spindle and slide the paper roll onto the spindle.
3.
Place the roll, with the print side (red grid) facing the thermal print head, into the compartment
by fitting the spindle into the grooves on either side.
4.
Unroll the beginning of the paper and close the Writer door.
5.
Overlap the unrolled paper on the Writer door.
6.
Set the paper type to Roll by selecting Setup > ECG > Writer Setup > Paper.

Turning on the System

Press the Power key to turn on the system. After the system has turned on, verify the following:
The ON/OFF LED lights up.
l
The startup screen appears without any errors, or, the system prompts you to enter the date
l
and time.
Enter the date and time if prompted.
If you encounter any problems powering on the system, see
page 141
2047426-001K
for troubleshooting instructions
"General Troubleshooting Tips" on
MAC™ 600
Equipment Overview
51