Troubleshooting; Resetting The Unit - Kenwood DMC-G7R Instruction Manual

Y
DMC-G7R(K-En)
Troubleshooting
Unit fails to turn
ON.
There is no
sound.
The unit does
not respond to
key operation.
Sound skips.
The MiniDisc
cannot be
removed from
the unit.
Recording or
editing is not
possible.
@ The AC adaptor is disconnected.
® The battery is depleted.
@ HOLD status is engaged.
@ The volume is at minimum level.
® The remote control or headphones are
disconnected.
@ HOLD status is engaged.
® The battery is depleted.
® The remote control or headphone plug is
not securely inserted.
@ The battery is depleted.
© The unit is in a place where there is
excessive vibration.
@ Track numbers and other written data are
being written to the disc ("TOC EDIT!" is
displayed).
@ Recording or editing is in progress.
® The MiniDisc's erase protector is in the Open
(engaged) position.
® Other equipment is not properly connected.
@ The AC adapter was disconnected or a
power failure occurred during recording or
editing.
@ The HOLD function (which prevents
accidental key operation) is engaged.
Resetting the unit
(2) (Wo) (K9) (>)
'Pull the AC adaptor out of the power outlet.
Remove the rechargeable battery.
} Wait about 30 seconds.
operate the unit.
The unit may not operate normally due to faulty handling or adverse power current effects caused
by impact, excessive static electricity load, or power drop during use.
If this occurs, take the following measures.
outlet.
Pull the AC adaptor
out of the power
@ insert plug securely. (P13
@ Charge the battery. (P13
® Deactivate HOLD status. (P60
(P17
(P16
@ (|ncrease the volume.
@ Insert plug securely.
® Deactivate HOLD status. (P60)
@ Charge the battery. (P13)
@ Insert plug securely. (P16)
@ Charge the battery. (P13)
® Move the unit to a place where
there is little vibration.
Or set to "Psave OFF". (P62)
@ Remove the disc after "TOC
EDIT!" is no tonger displayed.
(P37)
@ Remove the disc after recording
or editing has been completed
and the power has turned off.
@ Move the erase protector knob
to the Closed position. (P36)
@ Check connections. (P29)
@ Record or edit again.
® Cancel the HOLD function.
(P60)
Plug the AC adaptor
into the power outlet