Selecting Offset Direction; (Some Tm-261A Versions Only); Activating Tone Function - Kenwood TM-261A Instruction Manual

22
Selecting Offset Direction
Select whether the transmit frequency will be higher (+)
or lower (—) than the receive frequency.
Press [F], [SHIFT].
* Each time this key operation is repeated, the offset
direction changes as shown below.
aa + > - — > s — _ - ]
If the offset transmit frequency falls outside the transmit
band, transmit is inhibited until the transmit frequency is
brought within the band limits by one of the following
methods:
e Move the receive frequency further inside the band.
* Reverse the offset direction.
Note: When a split memory channel is currently in use, the offset
direction cannot be reversed.
@ Automatic Repeater Offset
(Some TM-261A Versions Only)
This function allows the transceiver to automatically take
care of setting the required offset direction of the
transmit frequency from the receive frequency. Access
"ARO" in Menu B in order to toggle Automatic Repeater
Offset either ON or OFF {page 17}. The default is ON.
The transceiver is programmed for offset direction as
shown below.
144.0
145.14
145.5 146.4
146.0 146.6
147.0 147.6
147.4 148.0 MHz
S: Simplex
Note: Automatic Repeater Offset is not activated when CTCSS
{page 36} or Reverse {page 23} is ON.
Activating Tone Function
Each press of [TONE] switches through the choices
shown below.
No Indicator —~ TONE —» CTCSS
("T") ("CT")
* The CTCSS indicator does not appear if the optional
TSU-8 is not installed.