PROGRAM SCAN
This type of scan is similar to VFO Scan except the
programmable aspect allows you to set scan limits to limit
the frequency range of the scan.
m@ Setting Scan Limits
1
Press [F]+ POWER ON to access Menu B.
2
Select "PGM.SCN" {page 17}.
3
Press [VFO].
¢
"LO" and the current lower limit appears. The default
is the currently selected frequency.
(lamvame f4
(Toe
2
|
MHz
tid (Ss*:*=C<STONES~—s#REEV
i]
4 Turn the Tuning control, or press microphone
[UPY[DWN], to display the desired lower limit.
¢
Press [MHz] if you want to change the frequency in
1 MHz steps.
5
Press [VFO].
e
"UP" and the current upper limit appears. The default
is the currently selected frequency.
*
Press [MHz] if you want to change the frequency in
1 MHz steps.
7
Press [VFO] to set the upper limit.
8
Press [F] or microphone [PTT] to exit Menu B.
Note:
@ = The fower limit must be lower in frequency than the upper limit.
@
The lower and upper frequency steps must be equal.
@
Selections must be made within approximately 10 seconds or the
previous mode is restored.
Confirming Scan Limits
1
Press [F]+ POWER ON to access Menu B.
2 Select "PGM.SCN" {page 17}.
3
Press [VFO].
¢
This is the lower limit.
4
Press [VFO] again.
«
This is the upper limit.
5
Press [F] or microphone [PTT] to exit Menu B.