Naming Memory Channels; Eereeeeee - Kenwood TM-261A Instruction Manual

e When you enter less than 6 digits, press [MHz], [F],
and 5 dots. When you recall a named memory channel, its
After storing a name, pressing [MN] toggles between
1 Press [MR] to select Memory Recall. channel.
2 Turn the Tuning control, or press microphone
Note:
[UP]/[DWN], to select the desired memory channel.
@ = /f you do not enter the next digit within 10 seconds, the digits
already entered are stored and the eniry cursor is cleared.
Switch OFF the power to the transceiver.
@
Names can be assigned only to memory channels in which you
have stored frequencies and related data.
Press [MN]+ POWER ON. * The stored names can be overwniten by repeating Steps 1 ~ 7.
*
The first digit blinks.
*
The stored names also are erased by clearing memory channels
{page 26}.
t
f
i 3 sr 9 "OVER
MHz TONE REV
5 Turn the Tuning control, or press microphone
[UP][DWN], to select the first digit.
¢ To enter a dot after the first digit, press [MR]. Pressing
[MR] again clears the dot.
6 Press [MN].
¢ The second digit blinks.
30