Cael/Veqo. Scan Vecictsiicahsatiqniminaieaginesias Anes; Call/Memory Scan - Kenwood TM-261A Instruction Manual

m@ Using Program Scan
1 Select a frequency equal to or between the
programmed scan limits.
2 Press [VFO] (1s), and Scan starts at the frequency
currently displayed.
¢ The 1 MHz decimal blinks while scanning is in
progress.
3 To reverse the scan direction, turn the Tuning
control or press microphone [UP}[DWN].
e Upward scan:
Turn the Tuning control clockwise, or
Press microphone [UP].
« Downward scan:
Turn the Tuning control counterclockwise, or
Press microphone [DWN].
4 To cancel Program Scan, press any key other than
microphone [UP]/[DWN]}.
Note:
@ Squeich must be closed for Scan to function {page 14}.
@ When the frequency step of the current VFO frequency differs
from the frequency step of the programmed frequencies, the step
size of the programmed frequencies is used for scanning. After
terminating the Scan function, the step size of the VFO frequency
is reset to the step size of the programmed frequencies.
CALL/VFO SCAN
Use Call/VFO Scan to monitor both the Call channel and
the current VFO frequency on the selected band.
1
2
Press [VFO] to select VFO mode.
Press microphone [CALL] (1 s) to start Call/VFO Scan.
¢ The 1 MHz decimal blinks while scanning is in progress.
To cancel Call/VFO Scan, press any key other than
microphone [UP}/[DWN].
CALL/MEMORY SCAN
Use Call/Memory Scan to monitor both the Call channel
and the memory channel last used.
1
2
Press [MR] to select Memory Recall mode.
Press microphone [CALL] (1 s) to start Call/Memory
Scan.
¢ The 1 MHz decimal blinks while scanning is in progress.
To cancel Call/Memory Scan, press any key other than
microphone [UP][DWN].