Hitachi PC-ARFG-E Installation & Operation Manual page 44

SERVICE & INSTALLATION MENU
4 Press " ", " ", " ", or " " to select the indoor unit to be set
and press "OK".
This screen is not displayed when only one indoor unit is
connected to the wired remote controller. (The screen in
Step 5 is shown.)
Function Selection
00-00
00-01
00-02
Select
OK
Indoor unit number
(Refrigerant system number-Address number)
5 Press " " or " " to select the type tab and press "OK".
→It changes in the order of "b-J" ↔ "K-P" ↔ "q-S" ↔ " ".
Function Selection : 00-00
b1: Heating temperature compensation due to uneven heat load
01: No compensation
b-J
01
b1 b7 00
K-P
b2 00 b8 00
b3 00 b9 00
q-S
b4 00 bA 00
b5 00 bb 00
b6 00 bC 00
OK Select
Type tab
6 Press " ", " ", " ", or " " to select the item to set from the list
area. Press " " and press " " or " " to change the setting
value.
After selecting the setting value, press " " to return to the
setting item selection mode.
To return to Step 5, press " " in the setting item selection
mode.
7 To confirm the setting, press " " in the tab selection mode.
39 PMML0565 rev.0 - 09/2021
ALL
Back
bd 00 C5 00
bE 00 C6 00
C1 00 C7 00
C2 00 C8 00
C3 00 C9 00
C4 00 CA 00
Back
List area
8 Select "Yes" and press"OK" to confirm the setting and return
to Step 2.
Select "No" and press"OK" to discard the settings and return
to Step 2.
Press " "to return to Step 5.
Confirm function selection setting?
Yes
OK Confirm
No
Back