Thermistor Calibration In Controller; Fan Speed At Cooling Thermo-Off - Hitachi PC-ARFG-E Installation & Operation Manual

SERVICE & INSTALLATION MENU

6.1.5 Thermistor Calibration in Controller

This function is used to calibrate detected thermistor
temperature in the wired remote controller.
The temperature compensation value can be set in 0.5°C
increments within a range of ±3.5°C.
1 Select "Installation Menu" on the Service & Installation
screen and press "OK".
Service & Installation
Service Menu
Installation Menu
Check Menu
Enter
OK
2 Select "Thermistor Calibration in Controller" setting and
press "OK".
Installation Menu
Test Run
Function Selection
Thermistor Selection
Input/Output
Thermistor Calibration in Controller
Enter
OK
3 Select the temperature compensation value by pressing " ",
" " and press "OK".
Temperature Compensation
4 Press " " or " " to select "OK ". Press "OK", the screen
returns to the "Installation Menu".
60 PMML0565 rev.0 - 09/2021
(Mon) 16:30
Back
(Mon) 16:30
Back
0.0ºC
Back

6.1.6 Fan Speed at Cooling Thermo-OFF

This function is used to set the fan speed of the indoor unit at
Cooling Thermo-OFF.
1 Select "Fan Speed at Cooling Thermo-OFF"on the
"Installation Menu" screen and press "OK".
Fan Speed at Cooling Thermo-OFF
Fan Speed at Heating Thermo-OFF
Indoor Unit Address Change
Address Check Operation
Address Initialization
OK Select
2 Press " ", " ", " " or " " to select the indoor unit. Press
If there is only one indoor unit connected to the wired remote
controller, this screen is not displayed. (The Step3 screen is
shown.)
Fan Speed at Cooling Thermo-OFF
00-00
00-01
00-02
OK Select
3 If " " or " " is pressed, the fan speed is selected in the
following order: "Unavailable" ↔ "Low" ↔ "BREEZE". Select
the fan speed and press "OK" to confirm the setting.
Fan Speed at Cooling Thermo-OFF:00-00
OK
Select
OK
4 Press" " to return to the "Installation Menu" screen.
Installation Menu
(Mon) 16:30
ALL
Unavailable
LOW
BREEZE
Back
"OK".
Back
Back