Panasonic DVCPRO AJ-D455P Service Manual page 20

1-6. Removal of Cylinder Unit
1. Remove the Mechanism Unit.
Refer to item 1-5.
2. Unscrew a screw (A).
3. Unscrew the 2 screws (B) and remove the T1
Guide.
T1Guide
Screws (B)
4. Disconnect a connector (C) which is connected to
the Mech. I/F Board on the Mechanism bottom
side.
5. Unscrew the 3 screws (D) which have spring, then
remove the Cylinder Unit without touching any
Mechanism parts.
Connectors (C)
1-7. Removal of Power Supply Unit
1. Unscrew the 4 screws (A) and lift-up the Power
Supply Unit.
2. Disconnect a connector (B) and remove the Power
Supply Unit.
Screw (A)
Screws (D)
Screws (A)
(a)
Notes:
1. When remove the Power Supply Unit, the
connector (a) which is connected to the Mother
Board and Power Supply Unit is disconnected.
2. Check the
securely.
1-8. Removal of Fan Motor
1. Unscrew the 6 screws (A) and remove the Rear
Jack Panel.
Screws (B)
2. Disconnect a connector P2 (C)
3. Unscrew the 2 screws (B) and remove the Fan
Motor.
Notes:
1. When remove the Rear Jack Panel, the connector
(a) which is connected to the Mother Board and
Rear Jack Panel is disconnected.
2. Check the connector has been connected securely.
DIS-3
Connector (B)
connector has been
(a)
Screws (A)
Connector P2 (C)
connected