Hitachi Central Station EX Installation Manual page 19

5. Press [SELECT] button to show the first 3 digits of current setting. Example of IP address is as follows.
(Example: 192.168.0.23)
(a) The contents in the square are shown on 7-segment LED.
NOTE: The value "0" for IP address, subnet mask and default gateway are indicated with "000".
(b) Press [SELECT] button to move the display to the left most range.
The third digit from the left will flash. (Example: 192.168.0.23)
(c) Press [LEFT] [RIGHT] [UP] [DOWN] button to show network address and to change setting.
Press [RIGHT] button to right scroll the indication by 1 digit. (Example: 192.168.0.23)
Press [LEFT] button to left scroll the indication by 1 digit. (Example: 192.168.0.23)
Press [UP] button to increment the right most number by 1.
(Example: 192.168.0.23 -> 193.168.0.23. Increments up to 9.)
Press [DOWN] button to decrease the right most number by 1.
(Example: 192.168.0.23 -> 193.168.0.23. decreases down to 0.)
(d) Press [SELECT] and indication is as follows and then indicates the number for the setting item.
1 second
6. To change other setting items, repeat step (4) to (5) as necessary.
NOTES:
1. Restart Central Station EX to activate the change. Shut the power off to confirm all LEDs go off, set
DSW3 to normal mode (1 and 5 pins ON) and then turn the power ON again.
2. Upon resetting to factory default setting, Central Station EX automatically restarts.
When restarting due to resetting to factory default setting, 7-segment LED once indicates "1" and
then returns to the normal indication.
NOTICE:
● Regarding the detail of IP address, subnet mask and default gateway, contact network administrator.
Subnet mask and default gateway need not be set if the network is exclusively for Central Station EX
and its peripheral. Regarding network security, contact network administrator.
A12124820A
1 second 1 second
17