Table of Contents
Advertisement
22.4 Editing Layout
Use the following procedures to edit layout.
Procedure Overview
(1)
Closing calculation tentatively
(2)
Deactivating Energy Calculation Software
(3)
Configuration data backup
(4)
Editing layout data
(5)
Verifying settings of monitoring and controlling
(6)
Activating Energy Calculation Software
NOTES:
●
If energy calculation is activated, avoid performing these procedures from 5 minutes before until 5
minutes after each hour (that is, from XX:55 to XX:05).
●
Avoid performing these works also from 00:00 to 02:00 if calculation interval is set as 24 hours.
If calculation interval is set as 1 hour, result for the hour while following those steps will not be calculated.
The result for the specific 1 hour will be combined with the result of the following hour.
Ensure USB flash memory or SD card is correctly inserted for saving data and data backup.
●
If Remote Access software is in use, close the software before changing settings.
(1) Closing calculation tentatively
Refer to "(1) Closing calculation tentatively" in "8.1 Adding, Editing, or Deleting Units" in the Installation
Manual for Energy Calculation Software.
(2) Deactivating Energy Calculation Software
Refer to steps (3)-1 to (3)-3 in "7.7 Preparation for Actual Use" in the Installation Manual for Energy
Calculation Software to deactivate Energy Calculation Software.
(3) Configuration data backup
Refer to "19. Backup/Activate" (page 82) to save data in USB flash memory or SD card.
(4) Editing layout data
Refer to "10. Register Layout" (pages 50-59) to edit layout data.
(5) Verifying settings of monitoring and controlling
Refer to "(1) Monitoring and Controlling" in "9.6 Test Run" (pages 47-49) to verify correct operation.
(6) Activating Energy Calculation Software
If Energy Calculation Software is in use, refer to "6.9 Verifying Registration and Activating Calculation"
in the Installation Manual for Energy Calculation Software to resume energy calculation.
88
A12124820A
Advertisement
Table of Contents
