Table of Contents
Advertisement
22.2 Adding, Editing, or Deleting RC Groups
Use the following procedures to change setting when remote controller group is added, edited, or deleted.
Procedure Overview (Refer to procedure steps in "22.1 Adding, Editing, or Deleting Units" (pages 85-86).
(1)
Closing calculation tentatively
(2)
Deactivating Energy Calculation Software
(3)
Configuration data backup
(4)
Verifying connection, and Adding, Editing, or Deleting units
(5)
Restarting Central Station EX and Extension Adapter
(6)
Adding, Editing, or Deleting groups
(7)
Adding, Editing, or Deleting blocks
(8)
Adding, Editing, or Deleting areas
(9)
Restarting Central Station EX
(10) Verifying settings of monitoring and controlling
(11) Schedule setting
(12) Setting Energy Calculation Software
(13) Activating Energy Calculation Software
NOTES:
●
If energy calculation is activated, avoid performing these procedures from 5 minutes before until 5
minutes after each hour (that is, from XX:55 to XX:05).
●
Avoid performing these works also from 00:00 to 02:00 if calculation interval is set as 24 hours.
If calculation interval is set as 1 hour, result for the hour while following those steps will not be calculated.
The result for the specific 1 hour will be combined with the result of the following hour.
Ensure USB flash memory or SD card is correctly inserted for saving data and data backup.
●
If Remote Access software is in use, close the software before changing settings.
22.3 Adding, Editing, or Deleting Groups, Blocks, or Areas
Use the following procedures to change setting when groups, blocks, and areas are added, edited, or deleted.
Procedure Overview (Refer to procedure steps in "22.1 Adding, Editing, or Deleting Units" (pages 85-86).
(1)
Closing calculation tentatively
(2)
Deactivating Energy Calculation Software
(3)
Configuration data backup
(4)
Adding, Editing, or Deleting groups
(5)
Adding, Editing, or Deleting blocks
(6)
Adding, Editing, or Deleting areas
(7)
Restarting Central Station EX
(8)
Verifying settings of monitoring and controlling
(9)
Schedule setting
(10) Setting Energy Calculation Software
(11) Activating Energy Calculation Software
NOTES:
●
If energy calculation is activated, avoid performing these procedures from 5 minutes before until 5
minutes after each hour (that is, from XX:55 to XX:05).
●
Avoid performing these works also from 00:00 to 02:00 if calculation interval is set as 24 hours.
If calculation interval is set as 1 hour, result for the hour while following those steps will not be calculated.
The result for the specific 1 hour will be combined with the result of the following hour.
Ensure USB flash memory or SD card is correctly inserted for saving data and data backup.
●
If Remote Access software is in use, close the software before changing settings.
A12124820A
87
Advertisement
Table of Contents
