Hitachi Central Station EX Installation Manual page 88

(6) Adding, Editing, or Deleting groups
Refer to "(2) Registering group" in "9.5 Register Monitoring Target" (pages 35-38) to verify the group
that the unit is added, edited, or deleted.
(7) Adding, Editing, or Deleting blocks
Refer to "(3) Registering blocks" in "9.5 Register Monitoring Target" (pages 39-42) to verify the block
that the group is added, edited, or deleted.
(8) Adding, Editing, or Deleting areas
Refer to "(4) Registering area" in "9.5 Register Monitoring Target" (pages 43-46) to verify the area that
the block is added, edited, or deleted.
(9) Restarting Central Station EX
Refer to "21.1 Restart Now" (page 84) to restart Central Station EX.
(10) Verifying settings of monitoring and controlling
Refer to "(1) Monitoring and Controlling" in "9.6 Test Run" (pages 47-49) to verify correct operation.
(11) Schedule setting
Refer to "9. Schedule" in the Operation Manual for Central Station EX to set schedule for units that are
added.
NOTE
● If a unit is added to existing group, the unit may appear to have schedule registered, but the schedule is
not registered for the given unit. Ensure to set the schedule for the unit also.
(12) Setting Energy Calculation Software
If Energy Calculation Software is in use, refer to "(12) Setting Energy Calculation Software" in "8.1
Adding, Editing, or Deleting Units" in the Installation Manual for Energy Calculation Software to set and
verify the unit that has been added or edited.
(13) Activating Energy Calculation Software
If Energy Calculation Software is in use, refer to "6.9 Verifying Registration and Activating Calculation"
in the Installation Manual for Energy Calculation Software to resume energy calculation.
86
A12124820A