TIME SETTING
To set the display to show the day of the week and the time of
day, proceed as follows:
<" :
-,"1':",
1/
....;-iJ.
nll_
...' L
U U_
/1
' "
NOTE: When the unit is first plugged in or there has been a
power failure for more than 10 minutes, the display
will blink and appear as shown above. Only the left
timer will blink.
:::J
D
..c
_
flEW
..
PlAY
FF _
IIPAUSE/STll .... _STOP
OSR.
SE~
REG
vbw.N:LJ
~A
r=--1
DO
~t:r
IIJllIIDl
I
[J
[;l [;]1
r
-,
-
St.OW
+
SP/lP/EP
1lMERAEC
t.4EMORY
RES£l
"""' M OO<'
~
L~
-
Timer setting example:
Set the clock for 'WED PM 7:23' (Wednesday at 7: 23 p.m.)
CD
Press the TIME ADJUST button and keep it pressed until
the end of the time setting procedure.
®
First, the day of the week sould be set. (The day of the
week flashes in the display.)
Press the CHANNE L!SET
(v )/( 1\)
buttons to set WED.
®
Press the SHI FT (+) button to set the flashing indicator to
the Hour position.
Press the CHANN EL!SET (v) /
(1\)
buttons to set the hour
of day. Set to PM 7.
®
Press the SHIFT
(+)
buttor) to set the flashing indicator to
Minute position.
Press the CHANN EL!SET (v) /
(1\)
buttons to set the min-
ute. Set to 23.
®
When the time adjust button is released, the clock will start
operating.
CD®
.
,
.
>
I
<
®®
NOTE: The colon between the Hour and 10 Minute digits in-
dicates seconds. In the first 30 seconds of each min-
ute the upper dot flashes. In the last 30 seconds the
lower dot flashes. The colon flashes in 2 second inter-
vals. This timer works by AC power line reference.
Check the present time about once a month (for ac-
curacy) and if necessary reset time.
- 18-
NOTE: Normally during Time Setting and Timer Program-
ming you will use the SHI FT (+) button to advance
to each in the sequence. However, if you need to
back up (for example, to correct a mistake) you can
use the SHIFT (-) button to go through each step in
the sequence in reverse order. This can be done either
on the VCR or by using the remote control.