Installing the 3-cell battery
CAUTION:
The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the 3-cell battery and provides a visual representation of the installation procedure.
Figure 30. Installing the 3-cell battery
Steps
1. Carefully push the battery filler upwards to attach it to the 3-cell battery.
2. Place the 3-cell battery along with the battery cable on the palm-rest and keyboard assembly.
3. Align the screw holes on the 3-cell battery to the screw holes on the palm-rest and keyboard assembly.
4. Replace the four screws (M2x4) to secure the 3-cell battery to the palm-rest and keyboard assembly.
5. Tighten the captive screw to secure the 3-cell battery to the palm-rest and keyboard assembly.
6. Connect the battery cable to the connector on the system board.
Removing and installing Field Replaceable Units (FRUs)
63