Table of Contents
Advertisement
Installing the speakers for Ultralight
CAUTION:
The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the speakers and provides a visual representation of the installation procedure.
Figure 40. Installing the speakers for Ultralight
Steps
1. Route the antenna cables along the routing guide.
2. Using the alignment posts and rubber grommets, place the speakers into the slots on the palm-rest and keyboard assembly.
NOTE:
To properly position the speakers, secure the rubber grommets into the hooks.
3. Route the speaker cable along the bottom side of the palm-rest and keyboard assembly. Then secure the speaker cable into
the routing guides on the palm-rest and keyboard assembly.
4. Connect the speaker cable to the connector on the I/O daughter-board.
Next steps
1. Install the
base
cover.
2. Install the
3-cell
battery.
3. Install the
4-cell
battery.
4. Install the
WWAN
card.
5. Follow the procedure in
After working inside your
computer.
Removing and installing Field Replaceable Units (FRUs)
73
Advertisement
Table of Contents
