Figure 45. Installing the display assembly
Steps
1. Place the display assembly on a flat surface.
2. Slide the base assembly at an angle and gently press down on the hinges to align the screw holes on the display hinges with
screw holes on the system board.
3. Replace the four screws (M2.5x5) that secure the display hinges to the system board.
4. Connect the camera cable from connector (CAM1) and disconnect the display cable from connector (LCD1).
5. Peel back the camera cable and display cable on the system board.
6. Replace the two screws (M2x3) that secures the camera cable bracket to the system board.
7. Replace the two screws (M2x3) that secures the EDP cable bracket to the system board.
Next steps
1. Install the
WWAN
card.
NOTE:
This procedure applies only to computers shipped with a WWAN card installed.
2. Install the
base
cover.
3. Follow the procedure in
Smart card reader
Removing the smart card reader
CAUTION:
The information in this removal section is intended for authorized service technicians only.
78
Removing and installing Field Replaceable Units (FRUs)
After working inside your
computer.