Table of Contents
Advertisement
Figure 42. Removing the display assembly
Steps
1. Remove the two screws (M2x3) that secures the EDP cable bracket on the system board.
2. Remove the two screws (M2x3) that secures the camera cable bracket on the system board.
3. Disconnect the camera cable from connector (CAM1) and disconnect the display cable from connector (LCD1).
4. Peel off the camera cable and display cable from the system board.
5. Remove the four screws (M2.5x5) that secure the display hinges to the system board and lift the hinges away from base 45
to 90 degrees to allow clearance for base removal.
6. Lift the base assembly slightly at an angle.
7. Lift the base assembly away from the display assembly.
NOTE:
The display assembly is a Hinge-Up Design (HUD) assembly and cannot be further disassembled once it is
removed from the bottom chassis. If any components in the display assembly are malfunctioning and is required to be
replaced, replace the entire display assembly.
Removing and installing Field Replaceable Units (FRUs)
75
Advertisement
Table of Contents
