Installing The Fan - Dell Latitude 7350 Owner's Manual

Figure 35. Removing the fan
Steps
1. Remove three screws (M2x3) that secure WLAN and WWAN brackets to the system board.
2. Disconnect the antenna cables from the connector (D1 and D2) and release the cables from the cable routing guides.
3. Remove the screw (M2x4) that secures the fan to the system board.
4. Disconnect the fan cable from the connector (FAN1) on the system board.
5. Lift and remove the fan from the system board.

Installing the fan

CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the fan and provides a visual representation of the installation procedure.
68 Removing and installing Field Replaceable Units (FRUs)