Table of Contents
Advertisement
Figure 63. Removing the keyboard
Steps
1. Peel the USH daughter-board flexible flat cable from the back of the keyboard.
NOTE:
This step applies only to computers shipped with a USH daughter-board installed.
2. Open the latch and disconnect the keyboard and keyboard backlight flat cable from the connector on the clickpad.
3. Remove the twenty-nine screws (M1.2x1.5) that secure the keyboard assembly to the system.
4. Carefully lift the keyboard assembly to remove it from the computer.
5. Separate the keyboard from the keyboard support plate.
NOTE:
If the keyboard support plate is replaced, transfer the re-usable rubber filler (for WLAN, 4G WWAN) or thermal
pad (for 5G WWAN) over to the new keyboard support plate.
Figure 64. Keyboard Support Plate for 4G WWAN
Table 31. Keyboard support plate
No
1
Keyboard Support Plate for 4G WWAN Components
Rubber bumper for 4G WWAN
Removing and installing Field Replaceable Units (FRUs)
93
Advertisement
Table of Contents
