Table of Contents
Advertisement
Next steps
1. Install the
base
cover.
2. Follow the procedure in
Speakers
Removing the speakers for Ultralight
CAUTION:
The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
WWAN
card.
4. Remove the
3-cell
battery.
5. Remove the
4-cell
battery.
About this task
The following image indicates the location of the speakers and provides a visual representation of the removal procedure.
Figure 39. Removing the speakers for Ultralight
Steps
1. Unroute the antenna cables from the routing guide.
2. Disconnect the speaker cable from the connector on the I/O daughter-board.
3. Peel the tape that secures the speaker cable to the palm-rest and keyboard assembly.
4. Note the speaker cable routing, and unroute the speaker cable from the routing guides on the palm-rest and keyboard
assembly.
5. Lift the speakers, along with the cable, off the palm-rest and keyboard assembly.
72
Removing and installing Field Replaceable Units (FRUs)
After working inside your
Before working inside your
computer.
computer.
Advertisement
Table of Contents
