Figure 61. Installing the power button
Steps
1. Place the power button into its slot on the palm-rest and keyboard assembly.
2. Adhere the fingerprint reader flexible printed circuits to the connector (FP1) on the palm-rest and keyboard assembly.
NOTE:
This step applies only to computers shipped with a power button with fingerprint reader installed.
3. Align the screw hole on the power button with an optional fingerprint reader to the screw hole on the palm-rest and
keyboard assembly.
4. Replace the two screws (M1.2x1.5 ) to secure the power button to the palm-rest and keyboard assembly.
Next steps
1. Install the
system
board.
2. Install the heat-sink.
3. Install the
5G WWAN
NOTE:
This procedure applies only to computers shipped with a 5G WWAN card installed.
4. Install the
base
cover.
5. Follow the procedure in
Keyboard
Removing the keyboard
CAUTION:
The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
M.2 2230 solid-state
card.
After working inside your
Before working inside your
drive.
computer.
computer..
Removing and installing Field Replaceable Units (FRUs)
91