Table of Contents
Advertisement
Using the Envelope Feeder
You can select the envelope feeder as the paper source
using the operator panel menu tree or the print driver
software on your computer. The envelope feeder will
not be available for selection unless it is properly
installed on the printer. Envelope weight should not
exceed 24 lbs.
Instructions for installing and removing the envelope
feeder are provided Chapter 2 of the Easy Printer Setup
Guide.
Follow these steps to load envelopes in the printer.
1.
Pull out the tray extension. Then squeeze the right
guide and slide it to the right.
4–18
User's Guide
2. Lift envelope weight out of the way.
3. Insert a stack of envelopes with so that the stamp
corner is facing up and to the left.
a. Make sure the envelopes are closed.
b. Fan the envelope stack before loading them into
the feeder.
c.
If the stack has excessive curl, bend the stack in
the opposite direction of the curl to flatten it.
d. Load the envelopes flap side down and short
edge toward the rear of the feeder.
4. Adjust the side guide to the size of the envelopes in
the feeder. Then lower the envelope weight onto the
envelope stack.
note:
Format the envelope in Landscape
Orientation. Using the envelope feeder, the text is
printed on the envelope side facing up. Envelopes feed
from the bottom of the stack.
Advertisement
Table of Contents
