Table of Contents
Advertisement
Printing Information Pages
You can use the operator panel menu tree to specify
start pages or print out information pages. These
settings are described below. To change them using the
operator panel menu tree, follow the instructions that
begin on page 3-7. Detailed instructions are also given
on page 4-21.
Auto Start Page
You use this setting to specify whether a start page is
printed when you turn on the printer. Options are On
(the default) or Off. The start page can be either a demo
or a test page (see Define Start Page below).
Define Start Page
You use this setting to specify what type of start page is
printed when you turn on the printer. Options are
Demo:
This page displays text and graphic samples
for verifying print quality. This is the default.
This page contains information about printer
Test:
specifications and settings.
See Auto Start Page above.
Font List
If you select this item in the operator panel menu tree,
you can choose to print two different font lists.
If you select this, the printer
Font List PostScript 2:
will print a list of resident fonts available for
PostScript emulation, as well as any downloaded
soft fonts, or fonts on the optional hard disk drive.
If you select this, the printer will
Font List PCL 5e:
print a list of resident fonts available for PCL 5e
emulation, as well as any downloaded soft fonts.
Menu Tree
If you select this item in the operator panel menu tree,
the printer will print a diagram of the menu options
available from the printer operator panel.
Test Page
If you select this item in the operator panel menu tree,
the printer will print information about printer
specifications and settings.
Using Hardware Settings
You can use the operator panel menu tree to change
hardware settings. These settings are described below.
To change them using the operator panel menu tree,
follow the instructions that begin on page 3-7.
Format Hard Disk
This setting becomes available in the operator panel
menu after you install an optional hard disk drive to the
printer. You use this setting to begin the procedure for
formatting the drive. Instructions for installing and
formatting the optional hard disk drive are in Chapter 2
of the Easy Printer Setup Guide.
Fuser Alarm
This setting becomes available in the operator panel
menu when the printer displays a
message. Message will continue to blink until you
replace the fuser unit and reset the fuser alarm. The
options are
This is the default.
Reset? No:
Select this after replacing fuser unit.
Reset? Yes:
Instructions for replacing the fuser unit are in Chapter 7,
"Maintaining Your Printer."
Operator Panel Tasks
REPLACE FUSER
3–5
Advertisement
Table of Contents
