Table of Contents
Advertisement
Loading Envelopes into the
Multipurpose Feeder
You can feed up to 10 envelopes at a time from the
multipurpose feeder.
Follow these steps, as illustrated on the next page.
1.
Push the top of the multipurpose feeder to open it
(A).
2.
Pull out the stopper (B).
3.
Pull out the extension tray (C).
4.
Slide the guide to the far right (D).
5.
Make sure the envelopes are not stuck together and
all the flaps are closed.
4–12
User's Guide
6. Insert the short side of the envelopes with the flaps
down along the left side of the tray and under the
plastic tab (E). The side to be printed should be face
up. If the envelope flap is on the short side, place
the envelopes so that the closed flap is fed first.
7. Adjust the side guide to the size of the loaded
envelopes. (F)
8. Adjust the tray extension so that the stopper lightly
touches the envelope stack.
The leading edge of the envelope that feeds into the
printer must be straight. The folded edge should be no
thicker than two paper thicknesses and no glue should
be exposed. It is highly recommended that double-side
seamed envelopes, rather than diagonal seams be used.
For further envelope specifications, see Appendix B.
note:
Using the multipurpose feeder, the image is
printed on the envelope side facing up.
Advertisement
Table of Contents
