Installing The Hp Netserver - HP D6030A - NetServer - E50 Installation Manual

Chapter 1

Installing the HP NetServer

1) Read the ReadFirst
Sheet
2) Connect Peripherals
3) Run HP Startup
CD-ROM
4) Run DiagTools
(Optional)
5) Read the NOS
Installation Guide
4
View the ReadFirst sheet from the HP NetServer E
200 Installation Kit. The ReadFirst Sheet is a quick
reference guide to help you install your HP
NetServer.
For details on rear panel interface connectors, refer to
Chapter 2, "Controls, Ports, and Indicators."
For details on connecting the keyboard, mouse,
monitor, and UPS, refer to Chapter 7, "Connecting
the Monitor, Keyboard, Mouse, and UPS."
Run the HP Startup (NOS drivers/Diagtools) CD
to create the diskettes necessary to install the
NOS drivers or test your NetServer's hardware
integrity.
The Startup CD-ROM also has a flash utility you
can use to backup your BIOS configuration, in
case the CMOS is corrupted later on.
Refer to Chapter 8, "Configuring the HP
NetServer."
To verify the HP NetServer hardware is fully
functional, boot from the DiagTools diskettes
and follow the screen instructions to run the
Basic Test.
View and then Save the Support Ticket, as this
will contain an inventory of your hardware.
Refer to Chapter 8, "Configuring the HP
NetServer."
Read the desired topic in the NOS Installation
Guide included in your NetServer E 200 Installation
Kit before starting to install the desired NOS. It
includes the instructions for installing all supported
NOSs and creating the NOS driver diskettes.
Refer to Chapter 8, "Configuring the HP NetServer."
Setting Up the HP NetServer