Removing Dimms - HP D6030A - NetServer - E50 Installation Manual

Chapter 5
f. If the latches do not close, the DIMM is not inserted correctly.
NOTE If the DIMMs are not seated properly, you may get a blank
screen when the NetServer boots.
8. Repeat all of Step 7 to install the additional DIMMs for your memory
configuration.
NOTE
Most DIMMs are dimensionally identical. So, if you have two
or more DIMMs installed, you should check all DIMMs are
seated by sliding a straight edge (a pen, for example) across the
top edges and verify it remains in continuous contact with all
of the DIMMs.

Removing DIMMs

You may need to remove a DIMM module to increase your memory configuration
or to replace a defective DIMM.
1. If the NetServer is already installed and working, gracefully power down
the NetServer.
Refer to Chapter 2, "Controls, Ports, and Indicators."
2. Disconnect the power cable and all external cables and, if necessary, label
them to support re-assembly.
WARNING The power supply will continue to provide standby current to
the NetServer until the power cable is disconnected.
3. Remove the top cover from the NetServer.
Refer to Chapter 3, "Opening and Closing the HP NetServer," for details.
4. Open the retaining latches.
5. Lift the DIMM completely away from the slot. See Figure 5-3.
Installing Additional Memory
33