Using The Scsi Configuration Utility; Configure/View Host Adapter Setting; Scsi Disk Utilities - HP D6030A - NetServer - E50 Installation Manual

Chapter 8

Using the SCSI Configuration Utility

The HP NetServer uses the Symbios SCSI Select Utility to configure or changes
SCSI settings. The SCSI Select Utility is used for verifying or modifying the SCSI
controller settings for the devices connected to SCSI controller board.
To access the SCSI Select Utility following the instructions on screen shortly after
the NetServer begins the boot process, a message appears:
<Ctrl A> for SCSI Select
NOTE
You typically would not need to use this utility unless you are
an experienced administrator or requested to do so by a support
provider.
There are two main topics under SCSI Select and each one is described under the
following topics:

Configure/View Host Adapter Setting

SCSI Disk Utilities

Configure/View Host Adapter Setting
Use this menu option to configure the SCSI controller and the devices connected
to it.
Host Adapter SCSI - Sets host adapter IDs.
Boot Device Options - Sets boot channel and boot SCSI ID.
Advanced Configuration Options - Reset SCSI, display <Ctrl><A>
message, enables or disables SCSI BIOS and features.
SCSI Disk Utilities
Use this menu option to format and verify media.
Select device - Select a device for low-level formatting or media
verification.
CAUTION Low-level formatting of a disk drive will destroy all of its
data.
58
Configuring the HP NetServer