Ide Mass Storage Additions; Scsi Mass Storage Devices; Scsi Controller Configuration - HP D6030A - NetServer - E50 Installation Manual

Chapter 4

IDE Mass Storage Additions

Table 4-1 lists the number and types of mass storage devices that may be added to
the IDE model of the HP NetServer.
Table 4-1. IDE Mass Storage Device Types
Interface Max Number of
Types Devices Possible
Flexible
disk drive
IDE-1
IDE-2
* You may connect an IDE Tape-backup device.
** An additional IDE cable is required if not configured with original order.

SCSI Mass Storage Devices

This section provides the configuration of the mass storage devices, if you have
selected a SCSI version of the HP NetServer E 200. Only one SCSI cable is
provided and it has four 68-pin, high-density connectors for the available hard
disk drive shelves. This cable also has a terminator on the end of the cable so it
does not require an enabled termination on the individual SCSI hard drive. The
base SCSI configuration has at least one SCSI hard drive connected to the factory
installed SCSI cable.

SCSI Controller Configuration

The SCSI controller board uses the Symbios (SCSI) Controller Utility to control
the SCSI controller settings. If you order the SCSI model, you typically do not
need to configure the SCSI controller, because the utility will automatically
recognize SCSI devices connected to it.
Run the SCSI Select Utility to verify or modify the SCSI controller settings,
low-level format SCSI disks, or verify SCSI media. Refer to Chapter 8,
"Configuring the HP NetServer," for further information.
Installed Devices and Addresses
1 Factory installed flexible disk drive in
shelf 1 (top shelf)
2* Factory installed CD-ROM drive in shelf 2
Factory installed IDE hard drive in shelf 3
Or optional IDE Tape-backup device in
shelf 3
2** Two optional IDE hard drives in the
removable mass storage cage (shelves 4
and 5)
Installing Mass Storage Devices
21