Removing Accessory Boards - HP D6030A - NetServer - E50 Installation Manual

Chapter 6
8. Slide the accessory board into the slot. See Figure 6-3.
Figure 6-3. Inserting an Accessory Board
9. Secure the accessory board using the screw you previously removed with
the slot cover.
Use the T-15 driver or flat blade screwdriver.
10. Once the accessory board is installed, you may need to install software
drivers.
The drivers for the new board are either part of your existing system
software or included on a flexible diskette included with the accessory
board.

Removing Accessory Boards

1. Apply the Steps 1 through 9 in reverse from the installation procedure to
remove the accessory boards.
2. Replace the slot cover on all empty slots to prevent EMI and cooling
problems.
40
Installing Additional Boards