Ide Mass Storage Devices; Ide Controller Configuration - HP D6030A - NetServer - E50 Installation Manual

Chapter 4
SCSI Model Boot Order:
1. IDE CD-ROM Drive
Flexible Disk Drive
3. IDE Hard drive (if boot drive)
4. SCSI A Channel (provided by SCSI Controller board)
5. PCI slot 1
6. PCI slot 2
7. PCI slot 3
8. PCI slot 4
9. ISA slot
On each SCSI Controller channel, the NetServer scans for a boot device starting at
device ID 0 and works up through the ID numbers (0-15). The SCSI controller
board is always SCSI ID 7. The optional tape drive will use SCSI address ID 4.
NOTE
The boot order can be changed using the NetServer's (BIOS
Setup) Utility (press [Del] during the boot process) and the
SCSI configuration utility.

IDE Mass Storage Devices

This section provides the configuration of the mass storage devices, if you have
selected an IDE version of the HP NetServer E 200.

IDE Controller Configuration

The embedded IDE controller is available for both models (IDE or SCSI) of the
HP NetServer. The embedded IDE controller is an Ultra DMA/66 E-IDE dual
channel controller, which provides IDE-1 and IDE-2 connectors. Each channel
can only control two IDE devices.
The base IDE NetServer model uses the IDE-1 connector for the IDE CD-ROM
and the IDE boot drive. The Setup Utility (BIOS) can be used to change the boot
order of the flexible disk drive and the IDE drive devices. Refer to Chapter 8,
"Configuring the HP NetServer," for more information.
20
Installing Mass Storage Devices