Installing Mass Storage Devices; Introduction; Tools Required; Boot Priority - HP D6030A - NetServer - E50 Installation Manual

4 Installing Mass Storage Devices

Introduction

This chapter describes how to install the internal mass storage devices, including
the internal hard disk drives (IDE or SCSI) and the optional Tape Backup (DAT)
Drive. The requirements for external SCSI drives are provided in the respective
topic later in this chapter.
The base HP NetServer E 200 comes standard with one flexible disk drive, one
IDE CD-ROM, and at least one SCSI or IDE hard disk drive. The removable mass
storage cage can hold an additional four hard disk drives with cabling.
Please refer to the appropriate section below according to your NetServer
configuration (IDE or SCSI).

Tools Required

Check your device's documentation for additional tool requirements.
1 Torx T-15 driver
1 ¼-inch flat blade screw driver

Boot Priority

The HP NetServer E 200 is provided in two models, IDE or SCSI, and the model
type affects the boot priority. The HP NetServer searches for bootable devices in a
specific order, which is set up in the BIOS Utility.
IDE Model Boot Order:
1. IDE CD-ROM Drive
Flexible Disk Drive
3. IDE Hard Drive
4. PCI slot 1
5. PCI slot 2
6. PCI slot 3
7. PCI slot 4
8. ISA slot
19