Opening And Closing The Hp Netserver; Introduction; Tools Required; Removing The Cover - HP D6030A - NetServer - E50 Installation Manual

3 Opening and Closing the HP
NetServer

Introduction

This chapter describes how to remove and replace the HP NetServer's main cover
and adjust the stabilizing feet on the bottom of the chassis.
WARNING

Tools Required

1 Torx T-15 driver
1 ¼-inch flat blade screwdriver

Removing the Cover

To remove the cover, follow these steps:
NOTE
1. Turn off the NetServer and disconnect the power cord and any phone line.
2. Unlock the cover, using the key in the key bag located on the rear of the
NetServer.
The locking mechanism is at the rear of the NetServer. See Figure 3-1.
3. Remove six (6) Torx T-15/slotted screws. See Figure 3-1 .
Before removing the cover, always disconnect the power cord
and unplug telephone cables. Disconnect the power cord to
avoid exposure to high energy levels that may cause burns
when parts are short-circuited by metal objects such as tools
or jewelry. Disconnect telephone cables to avoid exposure to
shock hazard from telephone ringing voltages.
These steps do not include the removal of the front bezel of the
NetServer. You do not need to remove the front bezel of the
HP NetServer E 200 to install internal accessories, such as
memory or mass storage.
13