Scsi Mass Storage Additions - HP D6030A - NetServer - E50 Installation Manual

Chapter 4
CAUTION You must not connect high voltage differential (HVD) SCSI
devices on the SCSI bus or you will damage the other LVD
SCSI devices.
The single channel Ultra Wide PCI SCSI controller board provided with the
NetServer SCSI model includes three SCSI connectors and is normally installed
on PCI slot 1.
1 internal 68-pin connector – This internal connector is used to control the
internal SCSI drives; up to a total of four SCSI drives.
1 internal 50-pin connector – This internal connector is provided but not
used.
1 external 68-pin connector – This external SCSI connector is only used
for external SCSI devices and requires no additional internal cabling or
jumper and switch settings. This connector can have up to 15 devices
connected to it externally.
NOTE
Only one connector can be configured for Channel A at a time.
Therefore, you could not have a SCSI device connected to the
external connector at the same time as internal SCSI devices
are connected to the internal 68-pin connector.

SCSI Mass Storage Additions

Table 4-2 lists the number and types of mass storage devices that may be added to
the SCSI model of the HP NetServer.
Table 4-2. SCSI Mass Storage Device Types
Max Number of
Interface
Types
Flexible
disk drive
IDE-1
22
Devices
Possible Installed Devices and Addresses
1 Factory installed flexible disk drive in
slot 1 (top shelf)
2*
Factory installed CD-ROM drive
in shelf 2 (Primary)
Factory installed IDE hard drive
in shelf 3, or
Optional IDE Tape-backup
device in shelf 3.
Installing Mass Storage Devices