Installing Accessory Boards - HP D6030A - NetServer - E50 Installation Manual

Chapter 6
NOTE The AGP Video board shipped with the HP NetServer has the
interrupt jumper on the board disabled. HP recommends
leaving this jumper in the disabled position, unless you are
using intensive video operations such as 3D rendering, which
can be improved by enabling this jumper on the AGP board.

Installing Accessory Boards

To install an accessory board, refer to the following procedure
1. If the NetServer is already installed and working, gracefully power down
the NetServer.
Refer to Chapter 2, "Controls, Ports, and Indicators."
2. Disconnect the power cables and any external cables connected to the
NetServer.
If necessary, label each one to expedite re-assembly.
3. Remove the cover and turn in the NetServer feet (so that the NetServer will
lay flat on its side).
Refer to Chapter 3, "Opening and Closing the HP NetServer."
WARNING The power supply will continue to provide standby current to
the HP NetServer E 200 until the power cable is disconnected.
CAUTION Wear a wrist-strap and use a static-dissipating work surface
connected to the chassis when handling components. Ensure
the metal of the wrist-strap contacts your skin.
4. Lay the NetServer on its side with the system board facing up (component
side up).
5. Read the documentation included with the accessory board and follow any
special instructions.
PCI boards must be set to INT A on the board if jumpers are provided.
6. Identify the accessory slot number to be used.
38
Installing Additional Boards