Board Assembly, Encoder Removal - Epson Stylus PHOTO 2000P Service Manual

EPSON Stylus PHOTO 2000P
When installing the Leaf Spring (6.2x 0.15x11), set it with
C H E C K
its convex side facing inward. Refer to Figure 4-49.
P O I N T
After setting SCALE, CR through the slot for the sensor
in the Carriage Unit, ensure that it is not in contact with
either side of the slot by viewing them from the side.
Carriage Unit
When installing SHAFT, CR, GUIDE, make sure that the
oil pad is set in the correct position.
DISASSEMBLY AND ASSEMBLY
Slit for the sensor
SCALE, CR
Disassembly Procedures

4.2.12 BOARD ASSEMBLY, ENCODER Removal

1. Remove the head FFC. (Refer to Section 4.2.4.)
2. Pushing BOARD ASSEMBLY, ENCODER (linear encoder) to the rear,
remove it upward.
Carriage Unit
Figure 4-51. BOARD ASSEMBLY, ENCODER Removal
When removing BOARD ASSEMBLY, ENCODER, be sure
C A U T I O N
not to force it out using a screw driver or equivalent.
Otherwise, the sensor mounting position in the Carriage
Unit may be damaged.
When installing BOARD ASSEMBLY, ENCODER, be
careful not to mar SCALE, CR.
Make sure SCALE, CR and the sensor are not in contact.
Revision A
BOARD ASSEMBLY, ENCODER
109