Epson Stylus PHOTO 2000P Service Manual page 112

EPSON Stylus PHOTO 2000P
13. Raise the two bushings (6) attached to the right and left ends of
ROLLER, PAPER EJECT to release them from FRAME, LEFT and
FRAME, MIDDLE. Them remove ROLLER, PAPER EJECT.
BUSHING, 6
Figure 4-56. ROLLER, PAPER EJECT Removal
14. Remove the one screw (CBS, 3x6) securing BRACKET, BOARD
ASSEMBLY to FRAME, LEFT together with BOARD ASSEMBLY,
ENCODER (PF Encoder Sensor). Then remove BRACKET, BOARD
ASSEMBLY.
CBS (3x6)
Figure 4-57. PF Encoder Removal
DISASSEMBLY AND ASSEMBLY
CONTACT SPRING, PF
ROLLER, PAPER EJECT
BRACKET, BOARD
ASSEMBLY
Disassembly Procedures
15. Remove CONTACT SPRING, PF hung to ROLLER, PF and FRAME,
BOTTOM. (Refer to Figure 4-56.)
16. Unhook BUSHING, 12, LEFT attached to the left end of ROLLER, PF
and then turn the bushing until it is aligned with the cutout in FRAME,
LEFT.
17. Release ROLLER, PF from the hook in PAPER GUIDE, REAR, and then
remove ROLLER, PF.
SPUR GEAR, 76
BUSHING, 12, LEFT
Figure 4-58. ROLLER, PF Removal
During disassembly/assembly, be careful not to bend or
C A U T I O N
damage SCALE, PF.
Do not touch SCALE, PF with your bare hands. Also, be
careful not to damage its surface since it is coated with
special material to improve accuracy in paper feeding.
Avoid touching the tooth plane of SPUR GEAR 76
attached to the left end of ROLLER, PF. (See Figure 4-58.)
Revision A
Hook in PAPER
GUIDE, REAR
ROLLER, PF
112