Epson Stylus PHOTO 2000P Service Manual page 83

EPSON Stylus PHOTO 2000P
C298PSB/PSE
Board
SHIELD PLATE, M/B
Earth Plate
CP (3x6)
Figure 4-4. Circuit Board Removal
6. For removing each circuit board assembly from the M/B Shield Plate,
remove the screws securing each unit and shield plate.
C304MAIN Board: Total 12 screws
9 screws: CBS (3x6)
3 screws: CP (3x6)
C298PSB/PSE Board: Total 4 screws (CBS, 3x6)
DISASSEMBLY AND ASSEMBLY
CBS (3x6)
C304MAIN Board
Earth Plate
Disassembly Procedures
Since the CN10 is a locking connector, be sure to unlock
C A U T I O N
it before disconnecting the cables.
Since the head FFCs have the same number of pins, be
sure to connect them to the right connectors.
When connecting the cables, connect them to the
correct connectors paying attention to the number of
the pins.
Be sure to perform the following adjustments when you
A D J U S T M E N T
R E Q U I R E D
replace the Main Board:
1. Initial ink charge
2. Head drive voltage input
3. Head angular adjustment
4. Bi-D adjustment
5. USB ID data input (Refer to Chapter 5.)
Be sure to replace the following parts when replace the
Main Board:
1. Waste ink absorbers
2. Ink cartridge (BK & Color)
Note this part replacement is required since several counters
stored in the EEPROM are lost with a Main board
replacement.
Revision A
83