EPSON Stylus PHOTO 2000P
4.2.1 HOUSING Removal
Since the printer mechanism itself structures the bottom part, it appears
just by removing HOUSING.
1. Open the printer cover and set the PG adjustment lever to (+).
2. Remove the four screws (CBS, 3x10) securing HOUSING, and remove
it.
C A U T I O N
When removing HOUSING, push it to the rear a little first,
and then lift it up.
When installing HOUSING, make sure the PG
C H E C K
adjustment lever is set to (+).
P O I N T
After assembling HOUSING, ensure the head
FFC is not caught in the back of HOUSING.
DISASSEMBLY AND ASSEMBLY
Disassembly Procedures
CBS (3x10)
CBS (3x10)
Figure 4-2. HOUSING Removal
Revision A
81