Scale, Pf Installation - Epson Stylus PHOTO 2000P Service Manual

EPSON Stylus PHOTO 2000P
When installing PAPER GUIDE, RIGHT to FRAME, TOP
C H E C K
with the torsion spring, insert PAPER GUIDE, RIGHT Unit
P O I N T
from the front making sure the PE sensor lever is set in
the hole of the paper guide.
TORSION SPRING,
117.6
PE Sensor Lever
Figure 4-59. PAPER GUIDE, RIGHT Installation
When mounting the torsion springs (117.6) to PAPER
GUIDE, UPPER / PAPER GUIDE, RIGHT, fit the arm of
each torsion spring (117.6) in the groove of the
corresponding paper guide.
When installing CONTACT SPRING, PF, fit the loop of the
spring in the groove near the left end of ROLLER, PF.
If you replace SCALE, PF (loop scale) or SPUR GEAR (76),
you are required to install a new SCALE, PF using the
specified tools. (Refer to the next section.)
DISASSEMBLY AND ASSEMBLY

4.2.13.1 SCALE, PF Installation

This section describes how to install the following parts:
1. Get "Mounting Plate Scale Attachment tool". (AS Tool code: 1051765)
2. Place BRACKET, SCALE on the tool with its taped side facing upward.
PAPER GUIDE,
3. Peel off the protection sheet from the tape on BRACKET, SCALE.
RIGHT Unit
Disassembly Procedures
SCALE, PF (Loop Scale)
BRACKET, SCALE
TAPE, D50 (Double-sided adhesive tape)
BRACKET, SCALE
Tool (Code: 1051765)
Figure 4-60. Pre-operation for BRACKET, SCALE Installation
Revision A
Protection Sheet
113