EPSON Stylus PHOTO 2000P
4.2.8 MOTOR ASSEMBLY, ASF Removal
1. Remove HOUSING (Refer to Section 4.2.1.)
2. Remove the harness for MOTOR ASSEMBLY, ASF from the main
board. (Refer to Section 4.2.2.)
3. Lower LEVER, PLANETARY UNIT.
[Lever is held up.]
Figure 4-21. Setting LEVER, PLANETARY UNIT
4. Remove the two screws (CBP, 3x8) securing MOTOR ASSEMBLY, ASF
to BRACKET, MOTOR, ASF. Then push the motor assembly to the rear
and then to the right to remove it.
DISASSEMBLY AND ASSEMBLY
LEVER, PLANETARY UNIT
[Lever is lowered.]
Disassembly Procedures
BRACKET, MOTOR, ASF
Figure 4-22. MOTOR ASSEMBLY, ASF Removal
C H E C K
When installing MOTOR, ASSEMBLY, ASF5, make sure
P O I N T
the DE unit and LEVER, PLANETARY UNIT are set as
shown below:
DE Unit (BRACKET,
MOTOR, ASF)
LEVER, PLANETARY
UNIT
Revision A
MOTOR ASSEMBLY, ASF
CBP (3x8)
95