Epson Stylus PHOTO 2000P Service Manual page 98

EPSON Stylus PHOTO 2000P
10. Remove the CBS screw (3x6) and CBP (3x8) screw securing the DE
unit to FRAME, MIDDLE and FRAME, TOP, respectively. Then remove
DE unit.
CBP (3x8)
Figure 4-27. DE Unit Removal
11. Remove the harnesses from the harness clamp in the DE Unit.
C A U T I O N Be sure to remove the screw (CBP, 3x8) carefully so you do
not damage the linear encoder (SCALE, CR).
DISASSEMBLY AND ASSEMBLY
SCALE, CR
CBP (3x6)
Disassembly Procedures
Check that all gears are assembled in the DE unit
C H E C K
correctly as shown in the figure below:
P O I N T
Combination Gear,
12, 22.4
Combination Gear,
17.19, 25.6
LEVER, PLANETARY UNIT
Figure 4-28. Parts Layout in DE Unit
Before assembling MOTOR ASSEMBLY, ASF to the DE
Unit, set LEVER, PLANETARY UNIT to the pump side.
(See Figure 4-28.)
Set TENSION BELT, PUMP, TRANSMISSION to the 17.19
gear of the Combination Gear (17.19, 25.6) before
securing the DE unit to FRAME, MIDDLE.
DE Unit
Revision A
Retaining Ring, D8.8
Felt, D3.6
Combination
Gear, 14, 28
BRACKET, MOTOR,
ASF
Combination Gear,
17.19, 25.6
TENSION BELT, PUMP,
TRANSMISSION
98