Epson Stylus PHOTO 2000P Service Manual page 37

EPSON Stylus PHOTO 2000P
Figure 2-5 gives the paper feeding mechanism block diagram, showing
the parts along the PF motor drive transmission paths.
Paper Eject Roller
Combination Gear
(13.5, 308)
Spur Gear (76)
PF Motor Pinion Gear
Figure 2-5. Paper Feeding Mechanism
The printer loads paper at the ASF, which is detected by the PE sensor
attached to the right side of the top frame, and advances it to send the
paper's leading edge to the halfway of the front paper guide. Then, to
correct paper deflection, the printer feeds the paper back specified steps
toward ASF, and advances the paper again toward the front paper guide
and stops it at the specified TOF (Top Of Form) position. Once printing
starts, the paper is fed by the PF rollers and sub rollers. For printing or
transporting the tailing edge area (14 mm), a notched roller and drive
from the paper eject roller are used. Like the Stylus Photo 750/1200, this
printer also provides this extra printable range of 14 mm from the bottom
edge, excluding the bottom margin of 3mm, by changing the position of
the star wheel gear; it has been shifted by 5
roller toward the front paper guide. Due to this change, the tailing edge of
paper is suppressed, and the printer can advance paper steadily. See
Figure 2-6 next page that shows how paper is transported and parts
involved.
OPERATING PRINCIPLES
PF Roller
Front Paper Guide
Paper Eject Roller
PF Motor
°
from the top of the eject
[Previous Models]
Notched Roller
Paper
Paper Eject Roller
[Stylus PHOTO 2000P]
Paper Eject Roller (round)
Figure 2-6. Paper Transportation
Notched roller is used for previous models as a paper eject roller. Stylus
PHOTO 2000P adopts a round roller to prevent a paper from notched
roller trace. When the paper setting on the printer and the actual paper
type differs and if the paper eject roller is tainted with ink because the
printer ejects paper before the printed surface would be dried, you have
to clean the roller by the roller cleaning function by the panel operation.
(See "Special Setting Mode" on page -22.)
Overview
Printhead
Platen Surface
Support Roller
PF Roller
Bottom Margin (3 mm)
°
5
Steady Feeding
Revision A
37