Netware Driver Installation; Installing Netware 3.1X - Asus PCI-DA2100 User Manual

memory space below 640K. Consult the manual for the particular
memory manager installed on your system for details on how to
install a device driver "high".
2 NetWare
The ASUS PCI-DA2100/-DA2200 drivers diskette contains the
following driver files for NetWare v3.1x, v4.0x, v4.1 and v4.11
respectively:
In sub-directory netware\v3_1x:
RAIDASPI.DSK : ASPI manager for NetWare v3.1x
DA2000.DDI : Installation Information File.
DA2000.DSK : Disk Driver for NetWare v3.1x
In sub-directory netware\v4_x:
RAIDASPI.DSK : ASPI manager for NetWare 4.0x, 4.1 and 4.11
DA2000.DDI : Installation Information File.
DA2000.DSK : Disk Driver for NetWare 4.0x, 4.1 and 4.11.
2.1

Installing NetWare 3.1x

Follow these procedures to install ASUS PCI-DA2100/-DA2200
drivers for NetWare 3.11 or 3.12.
1. Plug up to four ASUS PCI-DA2100/-DA2200 controllers into
host PCI slots then power on. The ASUS PCI-DA2100/-DA2200
BIOS will show the following messages on the screen for each
installed ASUS PCI-DA2100/-DA2200:
ASUS PCI-DA2100/-DA2200 (PCI-TO-SCSI RAID) BIOS vx.xx
PCI Bus # = 00 Device # = 0A Port = E800 IRQ = 11 EDORAM = 8MB FW=vx.xx
!! Press <Ctrl><I> for Configuration Utility, <Q> to Skip !!
2. Use the ASUS PCI-DA2100/-DA2200 BIOS Configuration Utility
to disable ISA Mailbox Emulation mode(default is disabled). To
do this, at system bootup, press [Ctrl-I], select Configure Card
option, then change IO Port Address to DISABLED.
3. Use ASUS Text RAID Manager to configure Logical Drives and
SCSI Devices and map them to valid SCSI-IDs/LUNs. Note that
SCSI ID 7 is reserved for the ASUS PCI-DA2100/-DA2200
ASUS PCI-DA2100/PCI-DA2200 User's Manual
®
Driver Installation
Appendix A
141