Installing Dram Simm - Asus PCI-DA2100 User Manual

4.2

Installing DRAM SIMM

IMPORTANT:
The ASUS PCI-DA2100/-DA2200 requires a minimum of 8 Mbytes of DRAM
in one SIMM (with or without parity function)installed in SIMM socket to
operate. The controller is normally delivered without any DRAM installed.
The following are guidelines with regards to DRAM:
Use 72-pin 60ns DRAM or 60ns EDO RAM SIMM modules. EDO
RAM is recommended to improve performance.
DRAM with or without parity is auto-detected by ASUS PCI-
DA2100/-DA2200, but DRAM with parity is recommended for
greater data integrity.
PCI-DA2100: A minimum of 2 Mbytes DRAM is required to be in-
stalled in the SIMM socket, however 4 Mbytes is recommended for
full functionality. Supports 8, 16, 32, and 64 Mbytes DRAM SIMM
modules up to 64 Mbytes.
PCI-DA2200: A minimum of 8 Mbytes DRAM is required to be in-
stalled in the SIMM socket, however 16 Mbytes is recommended for
full functionality.
SIMM modules
To install DRAM SIMM
1. Power off the system and disconnect the power connector.
2. Insert the DRAM SIMM paralleled with the key to the left (1). Then,
push towards the back until the hooks on both sides of the socket
snap into place (2) as shown below.
ASUS PCI-DA2100/PCI-DA2200 User's Manual
S
upports 8, 16, 32, 64, and 128 Mbytes DRAM
up to 128 Mbytes.
4
43