5.2
Installing Driver in an Existing OS/2 2.x/3.0
If you are adding an ASUS PCI-DA2100/-DA2200 controller to a
computer that already has an ASUS PCI-DA2100/-DA2200 controller
installed for OS/2 2.x/3.0, then follow step 1 through step 2 only. If
you are adding an ASUS PCI-DA2100/-DA2200 controller to a
computer that has no ASUS PCI-DA2100/-DA2200 controller
installed for OS/2 2.x/3.0, then follow all steps.
1. Use the ASUS PCI-DA2100/-DA2200 BIOS Configuration Utility
to disable ISA Mailbox Emulation mode(default is disabled). To
do this, at system bootup, press [Ctrl-I], select Configure Card
option, then change IO Port Address to DISABLED.
2. Use ASUS Text RAID Manager or RS-232 Terminal Interface
Operation to configure Logical Drives and SCSI Devices and
map them to valid SCSI-IDs/LUNs. Note that SCSI ID 7 is
reserved for the ASUS PCI-DA2100/-DA2200 controller and
thus no logical drives or devices should be mapped to this
SCSI ID.
3. Execute the program DDINSTAL by selecting the Device Driver
Install icon within the System Setup folder of OS/2 System folder
or by typing DDINSTAL at OS/2 prompt.
4. Insert the ASUS PCI-DA2100/-DA2200 distribution diskette in
the appropriate floppy drive and follow the instructions from
DDINSTALL. Set the source directory to a:\os2 and the
destination path to the root directory of system drive while
running DDINSTALL.
5. Reboot your system.
5.3
Updating PCI-DA2100/2200 OS/2 Device Driver
1. Copy the new device driver from the distribution diskette to the
root directory of system drive where that OS/2 is installed.
For example,
copy a:\os2\da2000.add c:\
ASUS PCI-DA2100/PCI-DA2200 User's Manual
Driver
Appendix A
165